AAC pulling device of mould Autoclaved Aerated Concrete Plant / AAC
The mould traction unit (see attached drawing) is a special unit
used to hook and push moulds along the car return line.
2. Technical specifications
a) The length of the mould traction unit is to be determined
according to the technical specifications.
b) Mass: 139.6 kg
c) Speed reducer
Output speed: 9.5 rpm
Form of installation: B3
Motor type: Y100L2-4
Speed: 1500 rpm
Power: 3 kW
The mould traction unit is made up of the following parts: steel
cable rewinder, pulley set No. 1, pulley set No. 2, tension device,
mould hooking and pushing car, and steel cables.
The mould hooking and pushing car is made up of the following
parts: bearings, wheels, hook, car body, shaft and etc.
Switch on the power and the motor should start running, driving the
steel cable rewinder to rotation. Steel cables are pulled through
pulley sets No.1 and No. 2 and thus the mould hooking and pushing
car travels along the rails.
5. Trial running and maintenance
a) Trial running:
The mould hooking and pushing car should run along the rails
smoothly and stably.
The wheels should be lubricated with #1 colloidal graphite
lubricating oil once a week.
a) Clear all obstacles away form the rails and their sides.